• Voltage Rating: 250V AC

• UL 94 flammability rating: V-0

• CE-marked (Low Voltage Directive)

• Standard color: black

10A snap-in type* inlet for cold conditions, per IEC320/C14

• 4.8mm (0.188") quick-disconnect (Q.D.) terminals**

• For panel thicknesses from 0.8mm to 2.0mm Panel cut-out

10A snap-in type* inlet for cold conditions, per IEC320/C14 with fuse holder for 1 or 2 fuses 5x20mm (6.3A max)

• L + N connected to fuse holder (double fused type)

• Solder terminals (L=4.8mm) on ground and fuse holder*

• Panel thickness from 1mm - 3mm

• Panel cutout dimensions: 26.8mm x 31.5mm

*For 4.8mm or 6.3mm Q.D. terminals on the fuse holder ask for type H1094
Type H1062 comes flanged, otherwise has similar construction.
Type H1074 is a snap-in type and has a unipolar switch (unfused)

10A (15A UL/CSA) snap-in type* outlet for hot conditions, per IEC320/C16

• 6.3mm Q.D. terminals

• Panel thickness: 3mm (can be supplied for panel thickness from 1.0mm - 4.0mm, please specify.)

• Panel cut-out dimensions: 27.7mm x 20.2mm

10A (15A UL/CSA) snap-in type* outlet for cold conditions, per IEC320/EN60320-2-2/F

• 6.3mm Q.D. terminals

• Panel thickness: 1.5mm(can be supplied for panel thickness from 1.0mm - 3.0mm, please specify.)

• Panel cut-out dimensions: 32.3mm x 24.7mm

Type H5098 comes with mounting flanges, otherwise has the same characteristics.

10A (15A UL/CSA) snap-in type* outlet for cold conditions, per IEC320/EN60320-2-2/F

• 6.3mm Q.D. terminals

• Mounting flange with through holes*

• Panel cut-out dimensions: 23.5mm x 16.0mm

*Also available with countersunk holes

10A snap-in type* power entry module for cold conditions, per IEC320/C14 Single fused, 5x20mm fuse (6.3Amax), ipolar switch, black

• 4.8mm Q.D. terminals on L,N + G, fuse holder and switch

• Panel thickness: 1.0mm to 2.0mm

• Panel cut-out recommendation:
  -Panel thickness up to 1.5mm:60.8mm x 27.2mm
  -Panel thickness >1.5mm: 61.5mm x 27.2mm

Type H5098 comes with mounting flanges, otherwise has the same characteristics.

• To be installed by qualified personnel only. Failure to wire as instructed may cause personal injury or damage to equipment! For
  factory assembly only.

• Remove outer jacket on cord 20mm, strip conductors 5mm

• Tighten wire clamp screws with a torque of 0.8Nm

• Tighten strain relief screws and cover screws with a torque of 0.5Nm

• Perform electrical tests and cord retention force tests

We have attempted to present the information about our vendor's products on this website in a straight-forward manner. We offer this information as accurate at the time of publication. Specifications are subject to change without notice. Electro-Stock, Inc. is not responsible for inadvertent errors.

About Us • FAQ • Services • Terms & Conditions • Policies

Since 1983